Posted by prieurbeer on December 12, 2006, 4:36 pm
Hi,
I recently bought my first Halrey. A sissy bar and saddle bag mountings
have been attached to the rear fender (struts). It is way too tight a
fit to get in under the fender to loosten the bolts, to remove these.
So what I'd like to know, is how to remove the rear fender, to enable
me to reach in under the fender to loosten these nuts/screws. Is this
really complicated?
Any help would be appreciated.
Thanx
Posted by Greasy Rider on December 12, 2006, 5:01 pm
On 12 Dec 2006 13:36:23 -0800, "prieurbeer"
>Hi,
>I recently bought my first Halrey. A sissy bar and saddle bag mountings
>have been attached to the rear fender (struts). It is way too tight a
>fit to get in under the fender to loosten the bolts, to remove these.
>So what I'd like to know, is how to remove the rear fender, to enable
>me to reach in under the fender to loosten these nuts/screws. Is this
>really complicated?
>Any help would be appreciated.
If you elevate the bike then the rear wheel should sag down enough to
get your hands under it. A Shop Manual would be a good investment.
Also check this when you can .....
r.m.h FAQ - http://rmhfaq.com
r.m.h parking lot - http://rmhparkinglot.com/
Ride Safe!
Greasy Rider® DOF/SLOB-6
'97 FLHTCI Lehman trike - Stage 0
53 years of motorcyling RETREAD-5238
( This line intentionally left blank. )
XML Sitemap
>I recently bought my first Halrey. A sissy bar and saddle bag mountings
>have been attached to the rear fender (struts). It is way too tight a
>fit to get in under the fender to loosten the bolts, to remove these.
>So what I'd like to know, is how to remove the rear fender, to enable
>me to reach in under the fender to loosten these nuts/screws. Is this
>really complicated?
>Any help would be appreciated.