Posted by Marino on August 31, 2009, 10:53 am
Greetings!
I own Hyosung Aquila 250, the new model with electronic fuel injection
(EFI). I have a problem with my bike!!!
My bike runs ok until it heats up, then, when I stop on red light or stop
sign, it begins to stall and shut down. I have to leave it couple of minutes
before I can start it again and then it runs for a short while and begins to
stall again, especially when I lower the throtle.
Could somebody help with any kind of advice concerning this problem?
Bye, Marino
Posted by The Older Gentleman on August 31, 2009, 11:06 am
> Greetings!
>
> I own Hyosung Aquila 250, the new model with electronic fuel injection
> (EFI). I have a problem with my bike!!!
> My bike runs ok until it heats up, then, when I stop on red light or stop
> sign, it begins to stall and shut down. I have to leave it couple of minutes
> before I can start it again and then it runs for a short while and begins to
> stall again, especially when I lower the throtle.
>
> Could somebody help with any kind of advice concerning this problem?
>
If it's new, surely it's under warranty?
--
BMW K1100LT Ducati 750SS Honda CB400F Triumph Street Triple
Suzuki TS250ER Coo, down to just five bikes!
If you don't know what you're doing, don't do it. And RTFM.
chateau dot murray at idnet dot com
Posted by Marino on August 31, 2009, 11:29 am
> If it's new, surely it's under warranty?
Yes it is. And right now it is in the dealer's service. But, people working
there don't have a clue what is the problem. They don't have any diagnostic
tool for the electronics and as far as I can tell don't have the proper
specialization for this bike...
At this moment I got a hint from a guy who owns Aquila 650i that he had the
same problem (at least the same symptoms) and that it was the tip-over
switch/sensor. I told that to the guys in the service and now they will try
to replace it. But I posted here to see if there are some more hints because
I am not sure that this is the problem...
Posted by The Older Gentleman on August 31, 2009, 11:55 am
> > If it's new, surely it's under warranty?
>
> Yes it is. And right now it is in the dealer's service. But, people working
> there don't have a clue what is the problem. They don't have any diagnostic
> tool for the electronics and as far as I can tell don't have the proper
> specialization for this bike...
> At this moment I got a hint from a guy who owns Aquila 650i that he had the
> same problem (at least the same symptoms) and that it was the tip-over
> switch/sensor. I told that to the guys in the service and now they will try
> to replace it. But I posted here to see if there are some more hints because
> I am not sure that this is the problem...
Not your problem. They sell, they have warranty, they fix, or you demand
refund or replacement bike.
--
BMW K1100LT Ducati 750SS Honda CB400F Triumph Street Triple
Suzuki TS250ER Coo, down to just five bikes!
If you don't know what you're doing, don't do it. And RTFM.
chateau dot murray at idnet dot com
Posted by Marino on August 31, 2009, 12:00 pm
> Not your problem. They sell, they have warranty, they fix, or you demand
> refund or replacement bike.
Good point there.
XML Sitemap
>
> I own Hyosung Aquila 250, the new model with electronic fuel injection
> (EFI). I have a problem with my bike!!!
> My bike runs ok until it heats up, then, when I stop on red light or stop
> sign, it begins to stall and shut down. I have to leave it couple of minutes
> before I can start it again and then it runs for a short while and begins to
> stall again, especially when I lower the throtle.
>
> Could somebody help with any kind of advice concerning this problem?
>