Posted by Nev.. on February 12, 2010, 4:27 am
G-S wrote:
> BT Humble wrote:
>
>> BTH
>> [1] Before Nev points out that that it would be possible to drill the
>> hole through the centre of the bushing the other way, the orientation
>> of the hole that I'm talking about is equivalent to a stack of
>> washers.
>
> I think you've left him some ambiguity BT...
What could be ambiguous about washers? http://bit.ly/ccmINq
Stacks of 'em... even better :)
Nev..
Posted by Marty H on February 12, 2010, 5:19 am
> G-S wrote:
> > BT Humble wrote:
> >> BTH
> >> [1] Before Nev points out that that it would be possible to drill the
> >> hole through the centre of the bushing the other way, the orientation
> >> of the hole that I'm talking about is equivalent to a stack of
> >> washers.
> > I think you've left him some ambiguity BT...
> What could be ambiguous about washers? http://bit.ly/ccmINq
> Stacks of 'em... even better :)
> Nev..
they aren't washers...they are dish rags
mh
(not that there is anything wrong with that)
Posted by BT Humble on February 13, 2010, 4:04 am
Nev.. wrote:
> G-S wrote:
> >BTHumble wrote:
> >>BTH
> >> [1] Before Nev points out that that it would be possible to drill the
> >> hole through the centre of the bushing the other way, the orientation
> >> of the hole that I'm talking about is equivalent to a stack of
> >> washers.
> > I think you've left him some ambiguity BT...
> What could be ambiguous about washers? http://bit.ly/ccmINq
> Stacks of 'em... even better :)
> Nev..
Bastard! Utter, utter bastard!
BTH
(See you at the Unaugural?)
Posted by antonye on February 11, 2010, 4:08 am
BT Humble wrote:
> Why didn't you just heat-treat it to remove the temper,
> then machine it using a cutting tool as usual?
Because it's quicker and easier to use the lathe and
a dremel to achieve the same end result?
--
Antony
Posted by BT Humble on February 11, 2010, 6:17 am
antonye wrote:
> BTHumble wrote:
> > Why didn't you just heat-treat it to remove the temper,
> > then machine it using a cutting tool as usual?
> Because it's quicker and easier to use the lathe and
> a dremel to achieve the same end result?
Fair enough.
BTH
(See George? That's all that was necessary.)
XML Sitemap
>
>> BTH
>> [1] Before Nev points out that that it would be possible to drill the
>> hole through the centre of the bushing the other way, the orientation
>> of the hole that I'm talking about is equivalent to a stack of
>> washers.
>
> I think you've left him some ambiguity BT...