k75 lube price, for splines and clutch

Posted by watt.mike on March 19, 2007, 10:44 pm

please rate
this thread

Hi everyone,

Does anyone know what it might cost to get the dealer to lube up the
splines and everything that has to do with rough shifting in the k75?

I'm gonna call the dealer but I want some opinions from you guys so I
can get more than one opinion.

any help appreciated!

Posted by Rayvan on March 20, 2007, 2:41 pm

On Mar 19, 7:44 pm, watt.m...@gmail.com wrote:

Just get a manual from the BMW dealer, then go to Honda and get "Honda
Moly Paste."

You'd be under a hundred bux!
--
Rayvan

Posted by Rob Kleinschmidt on March 20, 2007, 5:15 pm

On an R bike, you're talking 3+ hours with some skill and
tools required. The nth time isn't all that hard. The first is
a PITA. K-bikes are supposedly harder.

Posted by Werty on March 23, 2007, 5:26 pm

  Be careful , there is nothing better

than Moly-Di-Sulfide for sliding surfaces

but allow a microscopic particle

to enter a Ball bearing / anti-friction
bearing and heat goes WAY UP !

  Since MD is a plating thing , it plates
ball bearings and destroys them in minutes .

BTW i got ripped by
  $500 by

www. VXB . com

  Sam told me it was "hard" grease !!
  6002 / 6003 -2RS  and they made terrible
  noise rotating at low speed !
  It was a fight getting my $$ back .
.
I recently spent 5 years in Asia , so
i know the truth .  I dont deal with Asians .

Posted by P.Roehling on March 23, 2007, 8:22 pm

This will no doubt come as a great relief to all the Asians.