XJ600N Clutch Lubrication
Groups | Search | About
Login Password
Register Now! Lost Password?

Yamaha Bikes - Yamaha motorcycles discussed here 

Bookmark this page:  YahooMyWeb Yahoo!  Google Google  Windows Live Favorites Windows Live  del.icio.us del.icio.us  digg digg  Add to Netscape Netscape
Subject Author Date
XJ600N Clutch Lubrication Geoff Lane 06-16-2007
If you were  Registered and logged in, you could reply and use other advanced thread options
Posted by Geoff Lane on June 16, 2007, 3:39 pm
Recently I had a collapsed thrust bearing in my XJ600N.

Mileage at the time was just below 30k, naturally I had to clean a lot
of swarf off the inside of the clutch cover but thought the bearing
looked quite dry.

Anyway, replaced the bearing and been fine for a couple of months but
again I have a problem with the clutch, lot of rattling from the case so
I think the bearing may have collapsed again.

Until I get the case off I don't know but I have looked at the manual
and can't find any description of the clutch lubrication, I thought it
was just splash lubrications; can anyone enlighten me otherwise.

Geoff Lane

Posted by Albrecht via MotorcycleKB.com on June 16, 2007, 9:00 pm
Geoff Lane wrote:
>Recently I had a collapsed thrust bearing in my XJ600N.

What year? Is it a Seca II?

>Anyway, replaced the bearing and been fine for a couple of months but
>again I have a problem with the clutch, lot of rattling from the case so
>I think the bearing may have collapsed again.

Well, give it some clearance, mate.
>
>Until I get the case off I don't know but I have looked at the manual
>and can't find any description of the clutch lubrication, I thought it
>was just splash lubrications; can anyone enlighten me otherwise.

Yamaha seems to have run oil pressure through the hollow transmission main
shaft from what I can see by look at Seca II drawings.

http://www.bikebandit.com/partsbandit/showschematic.asp?dept_id=425217

13: NOZZLE

http://www.bikebandit.com/partsbandit/showschematic.asp?dept_id=425199

5: NOZZLE 2

--
Message posted via MotorcycleKB.com
http://www.motorcyclekb.com/Uwe/Forums.aspx/yamaha/200706/1


Posted by Geoff Lane on June 18, 2007, 4:17 pm
Albrecht via MotorcycleKB.com wrote:

>> Recently I had a collapsed thrust bearing in my XJ600N.
>
> What year? Is it a Seca II?

2000

> Yamaha seems to have run oil pressure through the hollow transmission main
> shaft from what I can see by look at Seca II drawings.
>
> http://www.bikebandit.com/partsbandit/showschematic.asp?dept_id=425217
>
> 13: NOZZLE
>
> http://www.bikebandit.com/partsbandit/showschematic.asp?dept_id=425199
>
> 5: NOZZLE 2

Thanks, I'll have a look.

Geoff Lane



Similar ThreadsPosted
V-star 650 -- clutch adjustment? October 8, 2007, 1:02 am
xt 250 clutch setup info needed.. July 23, 2007, 12:05 pm
2006 Vstar 650 Engine rev's when comming to a stop or pull clutch in May 24, 2007, 6:34 pm

Contact Us | Privacy Policy

XML SitemapXML Sitemap