XV250 Virago Regulator

Posted by Bob Dodds on December 8, 2007, 2:39 am

please rate
this thread

Can anyone tell me where the voltage rectifier/regulator mounts to a 1996
XV250 Virago. I've just replaced a burnt out harness so the whole bike was
in bits when I bought it and a complete rebuild is ongoing.. I've got the
manual but it isn't that clear where it fits. An XV125 would probably be
similar as I'm finding most parts are interchangable.

Thanks

Bob

Posted by Albrecht via MotorcycleKB.com on December 8, 2007, 10:01 pm

Bob Dodds wrote:

http://webservices.motorsportdealers.com/parts/partImages/YAM/3/02/0150/0039.Gif

Item #9 is the rectifier regulator.

--
Message posted via http://www.motorcyclekb.com

Posted by Bob Dodds on December 9, 2007, 8:22 am

Thanks that helps, but there is no mounting point where the picture shows
somewhere under the battery box. To the right side is the indicator and
control relay mounts and the rear is the igniter mounting bracket. On the
left side under the the side panel is a possibility but then it would be out
of any air flow and get no cooling, so I'm not sure if that's the right
place.

Regards

Bob

http://webservices.motorsportdealers.com/parts/partImages/YAM/3/02/0150/0039.Gif